Thanks for the quick response.
mjf55, answering your questions:
1- Does the nozzle scrape.if you use only XYZ ware?
2- There is a Z-offset setting in the control panel. I am not sure if it controls only the I itial height off the bed or all Z-access commands. If you decide to alter the settings, record the initial value in case to want to go back.
1- No, it does not. It works fine, but prints crappy
2- I thought of that, but the first layer is ok, I think. Does not touch, and plastic does come out. I might try raising it up a bit and see what happens.
Thanks for the ideas!
carl_m1968,
I´m a newbe, so bare with me here for a sec
I do understand what you mean by over extrusion, but I do not see that variable as configurable in CURA nor XYZ.
And as far of offset from layer to layer, I take you are positive about your comment on the offset of the Z axis not beeing applied to each layer. Did I get that right?
Because if that is the case, if the offset applies only to the first layer and no to the consecutive layers, then why does it not happen when printing with the XYZ software? Would you recommend trying a 0.2 layer instead of a 0.1?
Thanks again for the ideas.