1 Topic by coleke

  • coleke
  • coleke
  • Member
  • Offline
  • Registered: 2012-08-07
  • Posts: 166

Topic: Sleep message, then job completes without printing

Has anyone else run into the above situation? I was happily printing away, working over my New Year's day hangover, for most of the day (11am- 8p), all off of my Panelolu. After 8p, and some flying spaghetti monsters of a few failed prints, I tried to print again. But, when I selected the GCode, the printer homed, then told me it was sleeping. After it was done with its nap, it homed again, then shut off the extruder and bed temps, and killed the motors like it was completed. Was this a case of overheating, and my sanguino telling me to quit it while it rests?

Grand Rapids, Michigan
SD2 with Sanguinololu board, glass bed mod, E3d_v5 bowden version hotend (currently direct drive), Lawsy Mk5 jigsaw replacement, octopi printserver, drv8825(tiny troubles)

2 Reply by coleke

  • coleke
  • coleke
  • Member
  • Offline
  • Registered: 2012-08-07
  • Posts: 166

Re: Sleep message, then job completes without printing

Seriously, no one going to answer this? No one else has this problem? I have had great prints, though intermittently a print stops within the first few layers, goes to sleep, then ends. Lately it heats up, goes to sleep, ends print. This is frustrating.

Searching through this forum yielded no results but my own post. There was a non-resolved post on Google groups, but they are using a mac computer with RH; I am using the panelolu sd card. Obviously my computer was not in sleep mode.
I feel like I am shunned by this community.

Grand Rapids, Michigan
SD2 with Sanguinololu board, glass bed mod, E3d_v5 bowden version hotend (currently direct drive), Lawsy Mk5 jigsaw replacement, octopi printserver, drv8825(tiny troubles)

3 Reply by cmetzel

  • cmetzel
  • Member
  • Offline
  • From: Solidoodle2 #0091
  • Registered: 2012-08-22
  • Posts: 1,429

Re: Sleep message, then job completes without printing

I remember reading it but I have no earthly idea why it would happen.  Don't take it personal

4 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: Sleep message, then job completes without printing

I've seen the sleep message on the LCD when unplugging the hot end thermistor. Look at your temperature graphs in RH to see if they have any sharp drops and check your wiring.

lawsy's Website