1 Topic by Ggalisky

  • Ggalisky
  • Ggalisky
  • Member
  • Offline
  • From: California
  • Registered: 2014-05-21
  • Posts: 487

Topic: How to increase spiral vase speed in scli3r?

Does any one have any experience with this? I can only get one fixed speed when  checking the spiral vase setting.

Ulitmaker 2, a few repraps, Custom Big FFF 3D printer with heated chamber.

My Blog http://ggalisky.weebly.com/
My Youtube https://www.youtube.com/channel/UCXShYo … aDUpebDAOw

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: How to increase spiral vase speed in scli3r?

I just use the feed rate slider in R-H other than that you are being limited by other speed factors such as small perimeters and the like.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by mdrVB6

  • mdrVB6
  • Member
  • Offline
  • Registered: 2013-12-18
  • Posts: 717

Re: How to increase spiral vase speed in scli3r?

Did you check your filament cooling settings?  It could be limited by that as well.

SD4 w/ RUMBA, E3D Volcano, all bearings, glass bed