1 Topic by Pooncakes

  • Pooncakes
  • Newbie
  • Offline
  • Registered: 2014-08-25
  • Posts: 1

Topic: Solidoodle 3 Problems

Warning: I have a minimal knowledge in 3D Printing so bare with me. Right now my Solidoodle 3 is out of commission, because I installed a new Repetier but things went wonky. One day, for some reason in Repetier it would show my jobs being complete in seconds flat while the printer didn't even budge at all. I would have to unplug it from USB and the power source multiple times in order for it to even try and attempt a job and sometimes midway through the print it would do the same thing and show that it's completing the job in seconds flat on screen while in real life the printer just stops. Help me out please, Worst comes to worst, I can just install this on a new computer.

Thank you.

2 Reply by jagowilson (edited by jagowilson 2014-11-19 05:47:32)

  • jagowilson
  • PRINTiT
  • Offline
  • Registered: 2014-09-14
  • Posts: 1,701

Re: Solidoodle 3 Problems

Are you connecting to your actual printer or the default virtual printer? Does it respond to manual controls? Make sure the baud rate is set to 250,000 as this is what the firmware expects.

3 Reply by Hoswvu

  • Hoswvu
  • Member
  • Offline
  • Registered: 2014-02-15
  • Posts: 13

Re: Solidoodle 3 Problems

i am having the same issue right now.  I havent figured out how to fix it yet.  i have an SD4 though