1 Topic by tx-rogue

  • tx-rogue
  • Member
  • Offline
  • Registered: 2013-09-20
  • Posts: 34

Topic: Soli 2 E3D upgrade

I have my E3d finally and have it wired in .  I figured out that I have the Printrboard.  In the instructions for the firmware upgrade it says to make changes to the configuration.H file.  I honestly am not 100% sure where/how to do this. 

Can anyone walk me through this?

tia

S2 , E3d hotend,glass bed, stock otherwise,vista

2 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Soli 2 E3D upgrade

http://www.soliforum.com/topic/7917/e3d … intrboard/

Many Printrboard users found this walkthrough extremely helpful

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3 Reply by tx-rogue

  • tx-rogue
  • Member
  • Offline
  • Registered: 2013-09-20
  • Posts: 34

Re: Soli 2 E3D upgrade

Thanks Azerate.  I was able to get it  done.  With the recent updates  of RH though, I was not shown anything to indicate the upgrade worked.  I found our a little later the changes did work.

Thanks again

S2 , E3d hotend,glass bed, stock otherwise,vista