1 Topic by aaronboo

  • aaronboo
  • Member
  • Offline
  • Registered: 2012-11-23
  • Posts: 34

Topic: E3D on SD 4

Hello everyone,

I currently have a SD 4 with the new Metal Extruder, however I would wish to use it for E3D. However I realised that the Mount for the Metal Block is not suitable for the E3D. Anyone have any advice on how can I go about using the E3D while still retaining the Metal Block?

Should I just Re-Drill the hole on the metal block?

2 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: E3D on SD 4

This has been discussed a few times. It has been done and you are right...it does require a bit of work. You can read more at http://www.soliforum.com/topic/6355/upg … on/page/2/

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!