1 Topic by Serin

  • Serin
  • Serin
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 382

Topic: Ramps 1.4 firmware installation

Dumb question: Does one have to remove the RAMPS from the (in my case) Taurino board before installing the firmware?
I've seen it mentioned but I'm not sure if it's a requirement or just a preference.

This is a crowd funding thing that I'm running: http://www.gofundme.com/bvi140 It's for pretty selfish reasons tongue

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Ramps 1.4 firmware installation

What have you gotten yourself into??? smile  I can't see any reason why you can't flash it that way.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by Serin

  • Serin
  • Serin
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 382

Re: Ramps 1.4 firmware installation

wardjr wrote:

What have you gotten yourself into??? smile  I can't see any reason why you can't flash it that way.

Hahah an Ord Bot tongue
Adrian's being his usual awesome self and compiling the firmware for me.
Right, guess I'll just leave it as is, cheers dude.

This is a crowd funding thing that I'm running: http://www.gofundme.com/bvi140 It's for pretty selfish reasons tongue

4 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Ramps 1.4 firmware installation

Serin wrote:
wardjr wrote:

What have you gotten yourself into??? smile  I can't see any reason why you can't flash it that way.

Hahah an Ord Bot tongue
Adrian's being his usual awesome self and compiling the firmware for me.
Right, guess I'll just leave it as is, cheers dude.

Sure is nice having him help us all out like that I wouldn't have a working Rumba without him wink

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website