Topic: Fluctuating temperatures in both bed and extruder
So i have been getting the temperature is reset error alot. falling temperatures in both the bed and extruder. Eventually the bed stopped having problems and then Finally the extruder stopped heating up period. Went through and tested everything and found a fatigued wire going to the extruder. I replaced all the wiring and it worked fine and started printing. Then suddenly it got that error again and sure enough its holding the bed at 32 c and the exctruder at 50 c. When they should be at 215 and 105 respectively. If i hold a lighter to the extruder it goes right up in temperature so its not a thermoresister problem. And the fact that both the bed and extruder are having the issue makes me think there is a deeper problem. Any help would be great....im running out of stuff to fix.
p.s. the hot ends only a few months old. Also if i disconnect the software from the printer then re connect they start to heat up fine but will eventuallf fall and send the print job into error.
