Topic: extruder problems at the end of print
this is how my extruder path looks like. at the end of print it bumps onto the wall
snag.gy/PrrrP.jpg
please help me what to do
G-code of the procecss attached
Re: extruder problems at the end of print
your END GCODE is telling it to do that.
Check it,
And do a search on this forum, Lawsy did some very good End and Start Gcode sample for you to paste copy in your settings.
That helps a lot.
SD3, early 2013. Silicon 200W 8x8 heater bed, lawsy carriage on 8 mm hardened chrome shafts, E3D V6 and lawsy MK5 extruder, ATX 350 W PSU, Custom build plywood enclosure, azteeg x5 mini smothie firmware, with vikki 2 screen, fishing line conversion and pulley conversion, M5 Z rod. Calling it Gran'ma, going strong ! <3
Re: extruder problems at the end of print
it is the End Gcode of slic3r most definitely.
SD3, early 2013. Silicon 200W 8x8 heater bed, lawsy carriage on 8 mm hardened chrome shafts, E3D V6 and lawsy MK5 extruder, ATX 350 W PSU, Custom build plywood enclosure, azteeg x5 mini smothie firmware, with vikki 2 screen, fishing line conversion and pulley conversion, M5 Z rod. Calling it Gran'ma, going strong ! <3
Re: extruder problems at the end of print
So should I delete the end code ???
Re: extruder problems at the end of print
It didnt help modifying the start or end code
Re: extruder problems at the end of print
Last I checked there is a setting somewhere in Slic3r for start/end code. Look there in case there is some by default and remove it.
Also, does the printer actually crash from the code? It looks like it's homing and lowering the bed. Lowering the bed will make the part easier to remove and homing the nozzle is default I think. It should stop when it hits the limit switches.