1 Topic by pickartpower

  • pickartpower
  • Member
  • Offline
  • Registered: 2013-12-12
  • Posts: 18

Topic: Having an X Axis issue.

I Recently just received a shipment back from Solidoodle for a damaged board.
I've set it all back up, and I'm back to my very first original issue months ago when I first got it.

The X axis wont move. I adjusted the Trim Pot with no success. I rearranged the axis wires to see if it was a signal issue but after doing so it was still the same axis struggling to move.

Any ideas on the actions I should be taking next?

2 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: Having an X Axis issue.

careful how you rearrange wires as the stepper drivers are 'really' easy to fry....