1 Topic by elias

  • elias
  • Newbie
  • Offline
  • Registered: 2013-03-14
  • Posts: 8

Topic: Installation problems

Hi,

I have problems to get my Solidoodle to work on my Windows 7 machine. I installed the Repetier-Host Solidoodle and installed the driver. So far so good.

Launching the Repetier-Host I switched the COM-Port to COM4 as my Solidoodle is detected at this port in the control panel.

Connecting the printer results in following error in the terminal window of Repetier-Host:

Serial com error:System.IO.Ports.SerialErrorReceivedEventArgs

Any ideas what to do?

2 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: Installation problems

In printer settings in RH /connection tab,is it right there? Also is the baud rate 250000?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

3 Reply by spapadim

  • spapadim
  • Member
  • Offline
  • From: Jersey City, NJ, USA
  • Registered: 2013-05-16
  • Posts: 185

Re: Installation problems

If you copy paste that error message into google, top two hits:
http://wiki.solidoodle.com/installing-drivers
http://www.soliforum.com/topic/3576/ser … r-problem/

Did you try these? smile