1 Topic by Krythis

  • Krythis
  • Krythis
  • Member
  • Offline
  • From: Depew, NY
  • Registered: 2013-02-27
  • Posts: 185

Topic: Wavy Lines

Can someone help me understand what causes the waviness in individual extrusions pictured below? Is this possibly caused by over extrusion or play in the carriage?

http://i.imgur.com/kn4C2wM.jpg

E3D-v4 Hotend, MK5 carriage with round plastic wire conduit , 3/16" tempered glass,  Well nut, SureStepr SD8825 1/32 Extruder Driver, PowerEdge 2650 500W PS, QU-BD heated bed, circuit board fan, hinged plexiglass enclosure with plastic tray top. Other than that mostly stock SD3

2 Reply by Krythis

  • Krythis
  • Krythis
  • Member
  • Offline
  • From: Depew, NY
  • Registered: 2013-02-27
  • Posts: 185

Re: Wavy Lines

Ran into a random thread addressing this(moire?), may delete this thread shortly after further reading.

E3D-v4 Hotend, MK5 carriage with round plastic wire conduit , 3/16" tempered glass,  Well nut, SureStepr SD8825 1/32 Extruder Driver, PowerEdge 2650 500W PS, QU-BD heated bed, circuit board fan, hinged plexiglass enclosure with plastic tray top. Other than that mostly stock SD3

3 Reply by 2n2r5

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: Wavy Lines

Krythis wrote:

Ran into a random thread addressing this(moire?), may delete this thread shortly after further reading.

+1

Looks like you answered your own question. smile

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website