You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Solidoodle Discussion → heated enclosure
Do you think this would work to heat the enclosure.
http://www.oemheaters.com/p-6110-12v-dc … sfoot.aspx
I have an Azteeg X3 ordered and also have 12V 30A power supply.
I thought of using 2 ft of the heat cabel in the bottom of the enclosure and power it from the second
extruder with the thermalcouple on the board.
Yes, but you shouldn't need additional heat - in fact, you will may overheat the extruders or melt the printed parts. Without additional heat, I can get up to about 50C with my enclosure.
the reason for adding heat to the enclosure is I was told by the BOSS (my wife ) that I was taking up to much space in the Laundry room so the machine has been exiled to the Garage. Which is unheated.
Gotcha. That should work fine then. I'd think you'd only need 20w or so.
SoliForum - 3D Printing Community → Solidoodle Discussion → heated enclosure
Powered by PunBB, supported by Informer Technologies, Inc.
