<![CDATA[SoliForum - 3D Printing Community — heated enclosure]]> https://www.soliforum.com/topic/4012/heated-enclosure/ Sun, 22 Sep 2013 23:30:33 +0000 PunBB <![CDATA[Re: heated enclosure]]> https://www.soliforum.com/post/37048/#p37048 Gotcha. That should work fine then. I'd think you'd only need 20w or so.

]]> Sun, 22 Sep 2013 23:30:33 +0000 https://www.soliforum.com/post/37048/#p37048 <![CDATA[Re: heated enclosure]]> https://www.soliforum.com/post/37039/#p37039 the reason for adding heat to the enclosure is I was told by the BOSS (my wife ) that I was taking up to much space in the Laundry room so the machine has been exiled to the Garage. Which is unheated.

]]> Sun, 22 Sep 2013 22:31:57 +0000 https://www.soliforum.com/post/37039/#p37039 <![CDATA[Re: heated enclosure]]> https://www.soliforum.com/post/37034/#p37034 Yes, but you shouldn't need additional heat - in fact, you will may overheat the extruders or melt the printed parts. Without additional heat, I can get up to about 50C with my enclosure.

]]> Sun, 22 Sep 2013 22:23:57 +0000 https://www.soliforum.com/post/37034/#p37034 <![CDATA[heated enclosure]]> https://www.soliforum.com/post/37031/#p37031 Do you think this would work to heat the enclosure.
http://www.oemheaters.com/p-6110-12v-dc … sfoot.aspx

I have an Azteeg X3 ordered and also have 12V 30A power supply.
I thought of using 2 ft of the heat cabel in the bottom of the enclosure and power it from the second
extruder with the thermalcouple on the board.

]]> Sun, 22 Sep 2013 22:21:51 +0000 https://www.soliforum.com/post/37031/#p37031