1 Topic by shope

  • shope
  • Newbie
  • Offline
  • Registered: 2013-06-12
  • Posts: 6

Topic: L_HEATERS_ON_QUEST

I had some issues with end stops on my Solidoodle 3, so I followed the instructions for making a perfect circle and recalibrated the machine.  I also uninstalled and reinstalled the latest version of the software.  I made a couple more prints and now I get an error from Repetier:  L_HEATERS_ON_QUEST

All I can find by searching is that the error means -
id="L_HEATERS_ON_QUEST" ver="8">Some heaters are still on. Shall I disable them?

Does anyone know why I would receive this error, or how to avoid it?

2 Reply by shope

  • shope
  • Newbie
  • Offline
  • Registered: 2013-06-12
  • Posts: 6

Re: L_HEATERS_ON_QUEST

In addition - It doesn't matter whether I click Yes, No, or Cancel.  After the error goes away I can't do anything with the printer until I disconnect and reconnect.

3 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: L_HEATERS_ON_QUEST

Usually a popup box with the heater message appears when you disconnect from the print (and the heaters are still on).

When and where are you getting the error message?

lawsy's Website

4 Reply by shope

  • shope
  • Newbie
  • Offline
  • Registered: 2013-06-12
  • Posts: 6

Re: L_HEATERS_ON_QUEST

I am just a few seconds into the print when the error pops up.  If I clear and kill the job, then try to disconnect with the heater still on, I get the message again.  I'll double check all my connections and try again.

5 Reply by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Re: L_HEATERS_ON_QUEST

I had the same thing happen because the USB cable came unplugged (D^%^%$^ dog got tangled in the cord under the desk)
I had to turn the power off at the wall wart and start over.

Ultimaker S3.

6 Reply by shope

  • shope
  • Newbie
  • Offline
  • Registered: 2013-06-12
  • Posts: 6

Re: L_HEATERS_ON_QUEST

Thank you.  Apparently there was a loose connection somewhere.