1 Topic by nemesis200

  • nemesis200
  • Member
  • Offline
  • Registered: 2013-05-06
  • Posts: 24

Topic: repeiter host with slic3r

I have 1 computer for slicing and a second  net book connected to the printer.  I have been seeing that after  getting the gcode on my main computer and pulling it up on the second computer  that the model is no longer centered in the 3d view or on thr build platform that way it was on the main computer. does any onr have any IDeas why there is a differance  they are both running repetier host with slic3r

2 Reply by Downeasta

  • Downeasta
  • Downeasta
  • Member
  • Offline
  • From: Near - Ellsworth Maine
  • Registered: 2013-06-16
  • Posts: 120

Re: repeiter host with slic3r

Sounds like the bed configuration isnt the same or you have auto position turned off.

I am an open book, write on my pages that I may learn the wisdom that you posses.

Downeasta's Website

3 Reply by rose23

  • rose23
  • Newbie
  • Offline
  • Registered: 2013-07-12
  • Posts: 5

Re: repeiter host with slic3r

Check the setting and set it to 3d.

Technology Geeks