Topic: In-line Extruder Calibration Tube - (Level 1 - Novice Consumer)
Simple inline cal tube (1/4" OD 1/8" ID vinyl tube) with 1 cm marks. Easiest way to calibrate extruder. I am sure someone else has this but I haven't seen it.
Just make a mark with a permanent marker at the end of the tube. extrude 100mm or whatever you want and measure the difference from the nearest graduation.
Just thought that I would put this in it's own post so we have a level 1 mod.
SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.