1 Topic by Staffordknot

  • Staffordknot
  • Member
  • Offline
  • Registered: 2013-04-28
  • Posts: 199

Topic: Test print of cylinder... What should i configure next?

How is this looking? I'm not sure what to expect.

I've not done any xy or z configuration yet.

http://www.flickr.com/photos/97035392@N04/

Cheers

2 Reply by cckens (edited by cckens 2013-06-05 20:00:35)

  • cckens
  • Member
  • Offline
  • Registered: 2012-09-13
  • Posts: 591

Re: Test print of cylinder... What should i configure next?

Showing not available to look at...

EDIT:
Not shared I guess

3 Reply by Staffordknot

  • Staffordknot
  • Member
  • Offline
  • Registered: 2013-04-28
  • Posts: 199

Re: Test print of cylinder... What should i configure next?

Opps lol

Post's attachments

image.jpg
image.jpg 1.18 mb, file has never been downloaded. 

You don't have the permssions to download the attachments of this post.

4 Reply by cckens

  • cckens
  • Member
  • Offline
  • Registered: 2012-09-13
  • Posts: 591

Re: Test print of cylinder... What should i configure next?

It looks good... there's no noticeable z banding (the extreme kind, we all get some lines as this is layering), and the vertical looks straight.  Can't tell about the roundness so I can't comment on the xy aspects.

5 Reply by 2n2r5

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: Test print of cylinder... What should i configure next?

You could try the nickle calibration to get you x-y dialed in


http://www.thingiverse.com/thing:84795

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website