1 Topic by nickythegreek

  • nickythegreek
  • Member
  • Offline
  • Registered: 2012-11-18
  • Posts: 673

Topic: Z Platform Disassembly and Reassembly of Components

Solidoodle put up a new video, but I havent seen it linked anywhere yet. So I thought I would put up a post for those who might need the info.

"How to disassemble your z platform and reassemble components. Specifically this video is great for the z platform, z motor, and aluminum platform installation."

2 Reply by jefferysanders

  • jefferysanders
  • Banned
  • Offline
  • Registered: 2012-09-04
  • Posts: 309

Re: Z Platform Disassembly and Reassembly of Components

I noticed the updated wood bed platform with extra supports.

3 Reply by cmetzel

  • cmetzel
  • Member
  • Offline
  • From: Solidoodle2 #0091
  • Registered: 2012-08-22
  • Posts: 1,429

Re: Z Platform Disassembly and Reassembly of Components

Thanks ntg

4 Reply by mcsdaver

  • mcsdaver
  • Newbie
  • Offline
  • Registered: 2013-06-11
  • Posts: 5

Re: Z Platform Disassembly and Reassembly of Components

So the screw shaft is part of the Z stepper motor?
Mine seems to be bent near the motor and makes my print bed wobble also causes worse lines in a print than normal.
Can it be fixed or do I need a new Z stepper motor?

5 Reply by nlancaster

  • nlancaster
  • Member
  • Offline
  • Registered: 2013-03-20
  • Posts: 266

Re: Z Platform Disassembly and Reassembly of Components

mcsdavar, look in the hack upgrade section for replacing the screw.

6 Reply by 2n2r5

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: Z Platform Disassembly and Reassembly of Components

mcsdaver wrote:

So the screw shaft is part of the Z stepper motor?
Mine seems to be bent near the motor and makes my print bed wobble also causes worse lines in a print than normal.
Can it be fixed or do I need a new Z stepper motor?

Check out the slop nut in the hacks and mods section. Sounds like it would be perfect for you.

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website