1 Topic by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Topic: hot-end heater core

My resister on my hot-end went out and I need to replace it.
somewhere on this site I saw the 12v 40W heater cartridge at
qu-bd  mentioned. I can not find it.
will these work with the SD3

http://store.qu-bd.com/product.php?id_product=23

Ultimaker S3.

2 Reply by elmoret

  • elmoret
  • Filastruder
  • Offline
  • Registered: 2012-10-11
  • Posts: 6,048

Re: hot-end heater core

Factory hot ends are about 32W, so this will be a little higher output. The board and power supply can handle, it though. 5mm is the right hole size, too.

Filastruder - the robust, inexpensive filament extruder
E3Dv6 All Metal Hotend - the premier 3D printing hotend

3 Reply by dubbsd

  • dubbsd
  • dubbsd
  • Member
  • Offline
  • From: Northwest florida
  • Registered: 2012-09-30
  • Posts: 748

Re: hot-end heater core

Thanks for the quick reply Tim

Ultimaker S3.