<![CDATA[SoliForum - 3D Printing Community — hot-end heater core]]> https://www.soliforum.com/topic/1826/hotend-heater-core/ Sat, 23 Mar 2013 18:26:16 +0000 PunBB <![CDATA[Re: hot-end heater core]]> https://www.soliforum.com/post/17438/#p17438 Thanks for the quick reply Tim

]]> Sat, 23 Mar 2013 18:26:16 +0000 https://www.soliforum.com/post/17438/#p17438 <![CDATA[Re: hot-end heater core]]> https://www.soliforum.com/post/17437/#p17437 Factory hot ends are about 32W, so this will be a little higher output. The board and power supply can handle, it though. 5mm is the right hole size, too.

]]> Sat, 23 Mar 2013 18:23:32 +0000 https://www.soliforum.com/post/17437/#p17437 <![CDATA[hot-end heater core]]> https://www.soliforum.com/post/17436/#p17436 My resister on my hot-end went out and I need to replace it.
somewhere on this site I saw the 12v 40W heater cartridge at
qu-bd  mentioned. I can not find it.
will these work with the SD3

http://store.qu-bd.com/product.php?id_product=23

]]> Sat, 23 Mar 2013 18:15:38 +0000 https://www.soliforum.com/post/17436/#p17436