1 Topic by thatkinglouie (edited by thatkinglouie 2018-07-05 00:38:56)

  • thatkinglouie
  • Newbie
  • Offline
  • Registered: 2018-06-20
  • Posts: 9

Topic: da vinci mini (wireless) simplify3d 4.0.0 profile

i found a da vinci mini  .fff profile but the first few lines of a print is horrendous. that or the filament will ball up
anyone have a S3d profile? i know it's not the printer itself because if i use xyzware it prints "fine". just looking to see if S3d was better software

Post's attachments

XYZprinting Da Vinci Mini.fff 10.22 kb, 68 downloads since 2018-07-05 

You don't have the permssions to download the attachments of this post.

2 Reply by johnboyjr (edited by johnboyjr 2018-07-23 00:56:26)

  • johnboyjr
  • Member
  • Offline
  • Registered: 2015-12-08
  • Posts: 79

Re: da vinci mini (wireless) simplify3d 4.0.0 profile

make sure your z off set is is set low and use this

3 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: da vinci mini (wireless) simplify3d 4.0.0 profile

thatkinglouie wrote:

i found a da vinci mini  .fff profile but the first few lines of a print is horrendous. that or the filament will ball up
anyone have a S3d profile? i know it's not the printer itself because if i use xyzware it prints "fine". just looking to see if S3d was better software


The profile only gets you in the ballpark as it is machine specific. When I say machine specific I mean just that, not brand or model specific but machine specific. Every machine is different even under the same brand and model. So every profile will vary to some degree and will still require tweaks for a specific machine. The profile will simply get you in the ballpark and save a little time.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.