You are not logged in. Please login or register.
I have just got my Da vinci 1.0 Aio, some objects seem to prefer to have rafts when printing, the problem I have is that the machine produces quite a solid raft and it seems pretty firmly attached to the object I am printing. Is there an easy way to make the object easier to separate from the raft, is it just a case of moving the object vertically by 0.5mm or 1mm so it builds supports between the raft and the object?
Thanks
Adjust your bed using the manual method that is stickied in the XYZ section here. Then never use a raft again. The sole purpos for a raft is to compensate for bed alignment.
I have adjusted the bed by that method, everything was fine with the red Abs that came with the machine, but once I loaded the white it seemed as though as the print head crossed the support structure it was dragging and picking it up, the part I am printing has a very small contact area so supports are necessary, plus I was trying to print at 0.1mm steps so only a very thin coating of filament on the first pass. I think maybe a good cleaning of the nozzle might be in order.
The white that XYZ supplies is pure garbage and will alwsys fail. Just throw it away and count it as a learning experience. Avoid XYZ white at all cost.
Sorry, my bad, my white is actually natural, it actually seems to be working ok at the moment, so I will try that one again without the raft.
Powered by PunBB, supported by Informer Technologies, Inc.
