1 Topic by kmoore@turbonet

  • kmoore@turbonet
  • Newbie
  • Offline
  • Registered: 2017-03-08
  • Posts: 1

Topic: Coverting Da Vinci printer 1.0 to Repetier-Firmware

Hey All,

I wiped the Da Vinci firmware and installed the Repetier firmware per the instructions. It was a successful upload to the board but Repetier Host doesn't recognize the printer. Any suggestions?

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Coverting Da Vinci printer 1.0 to Repetier-Firmware

kmoore@turbonet wrote:

Hey All,

I wiped the Da Vinci firmware and installed the Repetier firmware per the instructions. It was a successful upload to the board but Repetier Host doesn't recognize the printer. Any suggestions?

Before you uploaded did you take note what the port speed was set for? Then you need to see what port the PC sees the printer at. Then set Repetier Host for that port and speed.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by pelo13

  • pelo13
  • Newbie
  • Offline
  • Registered: 2017-03-25
  • Posts: 1

Re: Coverting Da Vinci printer 1.0 to Repetier-Firmware

Hey!
Were did you find the instructions for the Repetier firmware conversion ?

Thanks..