<![CDATA[SoliForum - 3D Printing Community — Coverting Da Vinci printer 1.0 to Repetier-Firmware]]> https://www.soliforum.com/topic/16215/coverting-da-vinci-printer-10-to-repetierfirmware/ Sat, 25 Mar 2017 21:03:12 +0000 PunBB <![CDATA[Re: Coverting Da Vinci printer 1.0 to Repetier-Firmware]]> https://www.soliforum.com/post/133979/#p133979 Hey!
Were did you find the instructions for the Repetier firmware conversion ?

Thanks..

]]> Sat, 25 Mar 2017 21:03:12 +0000 https://www.soliforum.com/post/133979/#p133979 <![CDATA[Re: Coverting Da Vinci printer 1.0 to Repetier-Firmware]]> https://www.soliforum.com/post/133493/#p133493 kmoore@turbonet wrote:

Hey All,

I wiped the Da Vinci firmware and installed the Repetier firmware per the instructions. It was a successful upload to the board but Repetier Host doesn't recognize the printer. Any suggestions?

Before you uploaded did you take note what the port speed was set for? Then you need to see what port the PC sees the printer at. Then set Repetier Host for that port and speed.

]]> Wed, 08 Mar 2017 02:29:43 +0000 https://www.soliforum.com/post/133493/#p133493 <![CDATA[Coverting Da Vinci printer 1.0 to Repetier-Firmware]]> https://www.soliforum.com/post/133491/#p133491 Hey All,

I wiped the Da Vinci firmware and installed the Repetier firmware per the instructions. It was a successful upload to the board but Repetier Host doesn't recognize the printer. Any suggestions?

]]> Wed, 08 Mar 2017 02:17:28 +0000 https://www.soliforum.com/post/133491/#p133491