1 Topic by MartinFahrer

  • MartinFahrer
  • Member
  • Offline
  • Registered: 2013-11-07
  • Posts: 49

Topic: Not conecting to the computer

I haven't printed in over a year and moved the printer to my new work space.  I plugged my printer in and connected the usb but my computer will not recognize with the USB cable.  all the lights cum on and there is a slight hum but that is it.  Any hints or suggestions?

Thanks!

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Not conecting to the computer

You likely need to load the driver

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by MartinFahrer

  • MartinFahrer
  • Member
  • Offline
  • Registered: 2013-11-07
  • Posts: 49

Re: Not conecting to the computer

OK that got me connected but when I tried to run and spice this is what I got (See Pic).  No movement not even in"manual Mode"http://soliforum.com/i/?3dHd8jR.jpg

4 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Not conecting to the computer

try downloading an older version of Repetier host. I had timeout errors with newer versions as well.
Version 1.0.6 seems to work quite well for me

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

5 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Not conecting to the computer

Make sure you baud rate set in RH matches  the baud set in firmware.

Tin

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

6 Reply by MartinFahrer

  • MartinFahrer
  • Member
  • Offline
  • Registered: 2013-11-07
  • Posts: 49

Re: Not conecting to the computer

How do I find the baud rates in the firmware?