1.0A does not work after cartridge reset

I'm assuming that this is the first time that you reset a cartridge, and that also you are using a non XYZ printing filament for the first time. If that is the case, then the bed and extruder temperatures that worked for XYZ filament may not be optimal or even appropriate for the different filament you are using. Delaminating is most often the consequence of your extruder temperature not being high enough. Increase the extruder temperature by resetting that parameter with another reset of the cartridge and see how things go.

Thanks, I deleted them.  The server was struggling this morning when I posted.

Here is the thing... I spent hours last night troubleshooting, even took the whole head apart, cleaned it, and refit the thermistor.  Delamination with every print in the last 24 hours since resetting the cartridge.

I had about 20 hours of printing with other filaments, all working decently well with the original filament cartridge still in.

I reloaded the filament from the cartridge and reset it to the stock temperatures, but still, poor, brittle, delaminated prints.

So then, I opened up another XZY cartridge that I have, and loaded the filament.  Immediately, the keychain print worked great.  Loaded 3rd party filament, and now everything prints fine.

It is most certainly something in the EEPROM of the reset cartridge that is messing up prints with the 1.0A on 1.0.1 firmware.

There is something else that needs to be reset, other than the filament length, bed temp, and extruder temp...   The post that I referenced in OP stated that he had the same problem until he downgraded the FW on his 1.0, which is not an option with the 1.0A.

Does no one use stock firmware anymore???? LOL

Regardless, I know the solution here is to flash repetier, but I was hoping to solve this problem before I tackle that.

mpoffo, do you have a 1.0 or a 1.0A?

If the XYZzerocart can do this successfully, I'm sure it can be done.  I Arduino sketch I am using was posted over a year ago, so most likely something has changed, and I just need to find a newer sketch.

Do you use your XYZzerocart any longer?  Interested in selling if not?

I have a 1.0A

I bought the XYZZEROCART from this web site:

http://www.wctek.com/shop/12-xyz-accessories

I was not planning on selling mine just yet but that could change.  I thought I might try to pick up another used DaVinci but that is not certain.  I am leaning to building/buying an I3 Prusa as a second printer.

If I recall correctly the Z offset changes up/down by 1mm every time I went to reset a cartridge.  It took me a while to figure out what was going on.  After that it was just a matter of setting the correct Z offset in my slicer setting

I found a different reset sketch than the one I was using before.   Now it works great!

It started acting up again today after resetting my cartridge. I am convinced now that this has to do with the serial number on the cartridges. If it does not sense the right serial number increment, then it starts messing with the extrusion rate and your prints and up like crap.

I've learned what I can from xyz.  10 days is enough.  Going to repetier tonight.

http://www.soliforum.com/topic/12339/iv … n-duo-20a/

XYZware writes to the sd-card. And if you're connected the printer to the net then XYZ will write to the sd-card.

Well done dude. If I never had simplify3D I would maybe try what you've done.

Simplify3d was/is great on both stock and Repetier for me.  I like it much better than any other slicer but we all have our favorites. 

Never seen one. You could email them?

I use the resetter to do my temps on the bed\hotend.