Topic: Banging noises and warping
At the start of each print I get banging noises. Only at the start though as after 5 secounds its stops.
I am also getting warping on prints.
I have done the calibration and cleaned the extruder ect
Re: Banging noises and warping
I had what I would describe as "banging" noises only on the first layer and i'm guessing it was the extruder motor slipping. I increased the z-offset and it went away.
Re: Banging noises and warping
jwalker55 wrote:
I had what I would describe as "banging" noises only on the first layer and i'm guessing it was the extruder motor slipping. I increased the z-offset and it went away.
Ok how do I do that?
Re: Banging noises and warping
It happens to me too. Seems to do it more so when printing around the front right corner of the build plate. In the beginning of the print since it prints the purge lines in that corner I always get the banging when the print starts.
- artanangus
- Member
- Offline
Re: Banging noises and warping
I get the banging noises in the front right of the build plate too, mostly when doing the first couple of lines. Sometimes I can get it to be a little quieter if I gently help push the filament through. I don't know if the knocking or the assisting the filament is hurting anything.