1 Topic by cummingscha

  • cummingscha
  • Newbie
  • Offline
  • Registered: 2015-10-16
  • Posts: 5

Topic: Error Code 0030 - Anyone have a diagram I can use?

Hey guys

DaVinci AiO - it threw out error code 0030 last night after I leveled the printer and ran calibration.

Does anyone happen to have a diagram of the mainboard that identifies each wiring harness and their function for the printer? Trying some troubleshooting at the moment - checking resistance of wires mostly, but want to make sure I am looking at the correct set of wires.

Thanks

2 Reply by cummingscha

  • cummingscha
  • Newbie
  • Offline
  • Registered: 2015-10-16
  • Posts: 5

Re: Error Code 0030 - Anyone have a diagram I can use?

Solved the issue.

Issue was with red wire - three prong JST - that plugged into sensor for x-axis. Removed blue cable from door sensor, plugged into sensor and main board, cleared error.

Anyone know what JST style prongs xyz uses?

3 Reply by alexkaps

  • alexkaps
  • Member
  • Offline
  • Registered: 2015-02-20
  • Posts: 21

Re: Error Code 0030 - Anyone have a diagram I can use?

For daVinci 1.0A is PHR-4 on the board & PHR-6 on the stepper motor.