<![CDATA[SoliForum - 3D Printing Community — Error Code 0030 - Anyone have a diagram I can use?]]> https://www.soliforum.com/topic/13118/error-code-0030-anyone-have-a-diagram-i-can-use/ Sat, 26 Dec 2015 17:24:11 +0000 PunBB <![CDATA[Re: Error Code 0030 - Anyone have a diagram I can use?]]> https://www.soliforum.com/post/112609/#p112609 For daVinci 1.0A is PHR-4 on the board & PHR-6 on the stepper motor.

]]> Sat, 26 Dec 2015 17:24:11 +0000 https://www.soliforum.com/post/112609/#p112609 <![CDATA[Re: Error Code 0030 - Anyone have a diagram I can use?]]> https://www.soliforum.com/post/112012/#p112012 Solved the issue.

Issue was with red wire - three prong JST - that plugged into sensor for x-axis. Removed blue cable from door sensor, plugged into sensor and main board, cleared error.

Anyone know what JST style prongs xyz uses?

]]> Fri, 18 Dec 2015 03:25:42 +0000 https://www.soliforum.com/post/112012/#p112012 <![CDATA[Error Code 0030 - Anyone have a diagram I can use?]]> https://www.soliforum.com/post/112008/#p112008 Hey guys

DaVinci AiO - it threw out error code 0030 last night after I leveled the printer and ran calibration.

Does anyone happen to have a diagram of the mainboard that identifies each wiring harness and their function for the printer? Trying some troubleshooting at the moment - checking resistance of wires mostly, but want to make sure I am looking at the correct set of wires.

Thanks

]]> Fri, 18 Dec 2015 01:44:26 +0000 https://www.soliforum.com/post/112008/#p112008