1 Topic by nicholasfarquhar99

  • nicholasfarquhar99
  • Newbie
  • Offline
  • Registered: 2015-11-23
  • Posts: 1

Topic: Workbench will not connect w/ Cura

After hours of attempting to connect a Solidoodle Workbench to Cura in order to print, I was completely unsuccessful.  When attempting to connect, it would act as if it has not correctly connected to the software.  I tried to use MatterControl and Repertoire, but to no avail, it would still not connect.  Is there something simple that I am missing, or is this a common issue?

Thank you for your help

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Workbench will not connect w/ Cura

Firmware baudrate and host baudrate must match. Also confirm you have the correct comport selected.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.