1 Topic by pirvan (edited by pirvan 2015-08-22 05:04:35)

  • pirvan
  • pirvan
  • Member
  • Offline
  • From: San Francisco
  • Registered: 2013-03-27
  • Posts: 1,797

Topic: Fireman Figurine - From Scan to Print

Here is a print of a Warren Stratford figurine.

This is one of a few Stratford figurines I have scanned using the Atlas 3D scanner.  As I have mentioned in my post in the Atlas section the scanning process isn't perfect, but with a little bit of work, you can end up with a model that is very close to the original.

Here is the print of the Fireman next to the original.  It was printed in 2 halves @ .1mm.  Sliced with Cura, support generated by Meshmixer.  No retouching was done, only the supports were removed.

http://www.soliforum.com/misc.php?action=pun_attachment&item=9100

Post's attachments

Fireman print 001.jpg 311.16 kb, 6 downloads since 2015-08-22 

You don't have the permssions to download the attachments of this post.
To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.

2 Reply by AZERATE (edited by AZERATE 2015-08-22 04:41:22)

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Fireman Figurine - From Scan to Print

Great work! What is the size?
Layer settings would also help understand resolution in relation to the size.

Again, spectacular job. I wish I had the time to work on my Atlas (at software stage), so I'm living vicariously wink

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3 Reply by pirvan

  • pirvan
  • pirvan
  • Member
  • Offline
  • From: San Francisco
  • Registered: 2013-03-27
  • Posts: 1,797

Re: Fireman Figurine - From Scan to Print

it's 166mm, or about 6.5" tall

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.