<![CDATA[SoliForum - 3D Printing Community — Fireman Figurine - From Scan to Print]]> https://www.soliforum.com/topic/12121/fireman-figurine-from-scan-to-print/ Sat, 22 Aug 2015 04:58:17 +0000 PunBB <![CDATA[Re: Fireman Figurine - From Scan to Print]]> https://www.soliforum.com/post/104016/#p104016 it's 166mm, or about 6.5" tall

]]> Sat, 22 Aug 2015 04:58:17 +0000 https://www.soliforum.com/post/104016/#p104016 <![CDATA[Re: Fireman Figurine - From Scan to Print]]> https://www.soliforum.com/post/104014/#p104014 Great work! What is the size?
Layer settings would also help understand resolution in relation to the size.

Again, spectacular job. I wish I had the time to work on my Atlas (at software stage), so I'm living vicariously wink

]]> Sat, 22 Aug 2015 04:40:52 +0000 https://www.soliforum.com/post/104014/#p104014 <![CDATA[Fireman Figurine - From Scan to Print]]> https://www.soliforum.com/post/104013/#p104013 Here is a print of a Warren Stratford figurine.

This is one of a few Stratford figurines I have scanned using the Atlas 3D scanner.  As I have mentioned in my post in the Atlas section the scanning process isn't perfect, but with a little bit of work, you can end up with a model that is very close to the original.

Here is the print of the Fireman next to the original.  It was printed in 2 halves @ .1mm.  Sliced with Cura, support generated by Meshmixer.  No retouching was done, only the supports were removed.

http://www.soliforum.com/misc.php?action=pun_attachment&amp;item=9100

]]> Sat, 22 Aug 2015 04:14:07 +0000 https://www.soliforum.com/post/104013/#p104013