1 Topic by Zortwil

  • Zortwil
  • Member
  • Offline
  • Registered: 2014-07-18
  • Posts: 38

Topic: M3 Hardware

Not sure exactly where to post this, so sorry if it's in the wrong section.

I was wondering if anyone knew of some M3 assortment kits with hardware like nuts, screws, washers, etc.

Many mods and prints use these and I was wondering if there would be a better way than buying multiple packs of different sized screws every time I needed one.

Thanks!

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: M3 Hardware

might try looking for a screw kit for RC cars - they will have varying lengths in mostly M3 sizes with a few other sizes mixed in, depending on the car they are compiled for.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

3 Reply by mdrVB6

  • mdrVB6
  • Member
  • Offline
  • Registered: 2013-12-18
  • Posts: 717

Re: M3 Hardware

eBay.  I ordered a metric ton of M3 screws in several different lengths along with nuts, washers, etc.  I have hundreds of them and now I never even have to question if I have enough to do a mod.  Chinese sellers are fine for this and if you can wait 5- 15 days for epacket shipping, you can get them very cheap.

SD4 w/ RUMBA, E3D Volcano, all bearings, glass bed