1 Topic by Mike Perez

  • Mike Perez
  • Member
  • Offline
  • Registered: 2015-04-30
  • Posts: 14

Topic: Help

Please help davinci 1.0 xyz have a printer, but every time I try to print I get everything wrong calibrate and every time I print I always have to recalibrate , so every time you need to calibrate print ? And it is very difficult to find the values I can not leave it 230 235 235 .

2 Reply by milehighdesign

  • milehighdesign
  • Member
  • Offline
  • Registered: 2015-02-01
  • Posts: 15

Re: Help

Once I switched to Repetier firmware I hardly ever have to calibrate.  I only use the manual calibration in Repetier .92.
Before I made the switch I had to calibrate when switching from .4 to say .2 or .3 settings.

3 Reply by madmike8

  • madmike8
  • Member
  • Offline
  • Registered: 2014-12-30
  • Posts: 37

Re: Help

Stock firmware and software, and I've only calibrated once since I've gotten it. Check the bed leveling thread that is a sticky up top of this forum.

4 Reply by Mike Perez

  • Mike Perez
  • Member
  • Offline
  • Registered: 2015-04-30
  • Posts: 14

Re: Help

Thank you very much helped me a lot , thank you very much again for the help