https://www.soliforum.com/topic/11018/help/ Tue, 05 May 2015 18:32:36 +0000 PunBB https://www.soliforum.com/post/94968/#p94968 Thank you very much helped me a lot , thank you very much again for the help

]]> Tue, 05 May 2015 18:32:36 +0000 https://www.soliforum.com/post/94968/#p94968 https://www.soliforum.com/post/94936/#p94936 Stock firmware and software, and I've only calibrated once since I've gotten it. Check the bed leveling thread that is a sticky up top of this forum.

]]> Tue, 05 May 2015 04:57:05 +0000 https://www.soliforum.com/post/94936/#p94936 https://www.soliforum.com/post/94917/#p94917 Once I switched to Repetier firmware I hardly ever have to calibrate.  I only use the manual calibration in Repetier .92.
Before I made the switch I had to calibrate when switching from .4 to say .2 or .3 settings.

]]> Tue, 05 May 2015 02:29:29 +0000 https://www.soliforum.com/post/94917/#p94917 https://www.soliforum.com/post/94915/#p94915 Please help davinci 1.0 xyz have a printer, but every time I try to print I get everything wrong calibrate and every time I print I always have to recalibrate , so every time you need to calibrate print ? And it is very difficult to find the values I can not leave it 230 235 235 .

]]> Tue, 05 May 2015 02:19:12 +0000 https://www.soliforum.com/post/94915/#p94915