Topic: K resistor value at 3.3v positive
Does anyone know what the "k" resistor is on the circuit board. It is right at the 3.3v power input.
- carl_m1968
- Member
- Offline
Re: K resistor value at 3.3v positive
barry1685 wrote:
Does anyone know what the "k" resistor is on the circuit board. It is right at the 3.3v power input.
Could you post a picture. I have a stock board just collecting dust now but I see no resistor near the 3.3v input.
Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Re: K resistor value at 3.3v positive
Sure. See below.
Re: K resistor value at 3.3v positive
Bottom Resistor labeled "K" is R57 and top one is R47
5 2015-04-30 18:28:06 (edited by carl_m1968 2015-04-30 18:32:33)
- carl_m1968
- Member
- Offline
Re: K resistor value at 3.3v positive
barry1685 wrote:
Bottom Resistor labeled "K" is R57 and top one is R47
You have one of the newer boards. Those are just zero ohm resistors that are being used as fuses to my knowledge. Based off of other post where they have been burned. The second rev boards like mine do not have them
Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Re: K resistor value at 3.3v positive
Hmm. a while back I soldered a zero ohm resistor there and it made one of the diodes turn off furthering more problems to my board.
Re: K resistor value at 3.3v positive
Its not the best soldering job but that resistor is zero ohms.
Re: K resistor value at 3.3v positive
I found these on mouser, I'm not sure if they are the right fuses one is a 1206 and the other is a 0603 series 437 and 438
mouser.com/Search/m_ProductDetail.aspx? … bcXMv8V6g=
mouser.com/Search/m_ProductDetail.aspx? … omAxZUVpw=
Da Vinci AiO with firmware 1.1.1 using xyzscan 1.1.18
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter, Installed a Extruder Controller for higher temps
E3Dv6 hotend with custom carriage with Borosilicate glass bed
123D Design and Simplify3D, Replaced PS with a Solidgear Flex320
Zerokart resetter, Installed a Extruder Controller for higher temps