Topic: Next Stupid Question.... Am I Missing Some Set Screws?
From the pics below, should there be set screws in these holes (it's my Y-Axis Stepper)? There are 3 threaded holes with no set screws in there.
1 2015-04-25 18:23:17 (edited by Goshdarnit 2015-04-25 18:25:09)
- wardjr
- Moderator
- Offline
Re: Next Stupid Question.... Am I Missing Some Set Screws?
There needs to be at least one.
Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions
Re: Next Stupid Question.... Am I Missing Some Set Screws?
i looked here also have same as you no screws but the gear does not move if i try move it it stuck.
whats holding it in place if no screws?
Re: Next Stupid Question.... Am I Missing Some Set Screws?
There is a set screw in the second picture it is just really short.
Re: Next Stupid Question.... Am I Missing Some Set Screws?
workwesty wrote:
There is a set screw in the second picture it is just really short.
Thanks. What about the one behind that (the rear lower shaft)? Should there be one in that?
Re: Next Stupid Question.... Am I Missing Some Set Screws?
Us a flash light and look in the hole bet the is on too. You will need a hex head eventually so you can buy one and poke it in there.
Re: Next Stupid Question.... Am I Missing Some Set Screws?
I've already got one. I'll try that as soon as my current print either fails or finishes! 