SoliForum - 3D Printing Community — Next Stupid Question.... Am I Missing Some Set Screws?

Re: Next Stupid Question.... Am I Missing Some Set Screws?

null@example.com (Goshdarnit) — Sun, 26 Apr 2015 14:10:47 +0000

I've already got one. I'll try that as soon as my current print either fails or finishes!

null@example.com (workwesty) — Sun, 26 Apr 2015 13:40:15 +0000

Us a flash light and look in the hole bet the is on too. You will need a hex head eventually so you can buy one and poke it in there.

null@example.com (Goshdarnit) — Sun, 26 Apr 2015 13:06:19 +0000

workwesty wrote:

There is a set screw in the second picture it is just really short.

Thanks. What about the one behind that (the rear lower shaft)? Should there be one in that?

null@example.com (workwesty) — Sun, 26 Apr 2015 12:42:26 +0000

There is a set screw in the second picture it is just really short.

null@example.com (selkess) — Sun, 26 Apr 2015 11:26:05 +0000

i looked here also have same as you no screws but the gear does not move if i try move it it stuck.
whats holding it in place if no screws?

null@example.com (wardjr) — Sat, 25 Apr 2015 18:38:09 +0000

There needs to be at least one.

null@example.com (Goshdarnit) — Sat, 25 Apr 2015 18:23:17 +0000

From the pics below, should there be set screws in these holes (it's my Y-Axis Stepper)? There are 3 threaded holes with no set screws in there.