1 Topic by Goshdarnit (edited by Goshdarnit 2015-04-29 16:44:31)

  • Goshdarnit
  • Member
  • Offline
  • Registered: 2015-03-05
  • Posts: 162

Topic: Aaaaaaaaaggghhhh!! X-Axis Problem Now!

OK, on to the next problem.

My X-Axis has a shifting issue, but I don't think it's the usual one. If it is travelling left to right, it pauses for a fraction of a second, like a stutter. It always seems to be in more or less the same position, around 60mm from the right side of the bed. It's a tiny pause, but it's like the printer thinks it has continued moving during the pause, because it then stops early, causing the right wall of the item to shift left a bit between layers.

Hard to explain, but anyone have any ideas?

2 Reply by workwesty

  • workwesty
  • Member
  • Offline
  • Registered: 2015-01-15
  • Posts: 45

Re: Aaaaaaaaaggghhhh!! X-Axis Problem Now!

Check the the voltage.

3 Reply by Goshdarnit

  • Goshdarnit
  • Member
  • Offline
  • Registered: 2015-03-05
  • Posts: 162

Re: Aaaaaaaaaggghhhh!! X-Axis Problem Now!

That could be it actually. Now I think about it, I have just had to repair the extruder motor wire and now you've said that I think I remember reading somewhere that can mess up your voltages. I'll try that. Thanks.