<![CDATA[SoliForum - 3D Printing Community — Aaaaaaaaaggghhhh!! X-Axis Problem Now!]]> https://www.soliforum.com/topic/10913/aaaaaaaaaggghhhh-xaxis-problem-now/ Sat, 25 Apr 2015 18:19:24 +0000 PunBB <![CDATA[Re: Aaaaaaaaaggghhhh!! X-Axis Problem Now!]]> https://www.soliforum.com/post/94144/#p94144 That could be it actually. Now I think about it, I have just had to repair the extruder motor wire and now you've said that I think I remember reading somewhere that can mess up your voltages. I'll try that. Thanks.

]]> Sat, 25 Apr 2015 18:19:24 +0000 https://www.soliforum.com/post/94144/#p94144 <![CDATA[Re: Aaaaaaaaaggghhhh!! X-Axis Problem Now!]]> https://www.soliforum.com/post/94142/#p94142 Check the the voltage.

]]> Sat, 25 Apr 2015 18:05:13 +0000 https://www.soliforum.com/post/94142/#p94142 <![CDATA[Aaaaaaaaaggghhhh!! X-Axis Problem Now!]]> https://www.soliforum.com/post/94140/#p94140 OK, on to the next problem.

My X-Axis has a shifting issue, but I don't think it's the usual one. If it is travelling left to right, it pauses for a fraction of a second, like a stutter. It always seems to be in more or less the same position, around 60mm from the right side of the bed. It's a tiny pause, but it's like the printer thinks it has continued moving during the pause, because it then stops early, causing the right wall of the item to shift left a bit between layers.

Hard to explain, but anyone have any ideas?

]]> Sat, 25 Apr 2015 17:17:40 +0000 https://www.soliforum.com/post/94140/#p94140