1 Topic by DigitalWhitewater

  • DigitalWhitewater
  • Member
  • Offline
  • Registered: 2012-11-25
  • Posts: 128

Topic: Rumba Firmware upgrade

Hi All,

Was looking to upgrade my hotend on my SD2 w/ Rumba, so I just ordered the E3Dv6. I know I'll need to update my firmware appropriately.

So with that said... It's been a while since i've been in the forums so I just had two quick questions;

1) Link to the latest marlin release?
2) Am i able to use the current Arduino software available online, or do I need a previous release?

SD2 w/ mods: Rumba controller, ATX PSU, SD pro case, glass bed, with more to come...

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Rumba Firmware upgrade

https://github.com/ozadr1an/Solidoodle- … in_v1_beta
Latest version is fine

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by DigitalWhitewater

  • DigitalWhitewater
  • Member
  • Offline
  • Registered: 2012-11-25
  • Posts: 128

Re: Rumba Firmware upgrade

Thank you, Thank you, And Thank you!

SD2 w/ mods: Rumba controller, ATX PSU, SD pro case, glass bed, with more to come...

4 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Rumba Firmware upgrade

Your welcome, feel free to ask questions if you get stumped.  The endstop logic is going to throw you for a loop wink

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website