1 Topic by tullioperinetti

  • tullioperinetti
  • Newbie
  • Offline
  • Registered: 2015-04-21
  • Posts: 4

Topic: Model printing doesn't start

Hello, I did all starting procedures, calibrating is fine (extruder works, X and Y axis move correctly, Z works).
Also the model seems loaded correctly. Eventually the printing doesn't starts.
When I press the "print" button the process green bar loads the very first part and then it stops.
I have been trying also with old version of the software but nothing changes.
Anyone knows how to make it start?
http://soliforum.com/i/?zzQ0Mj3.png

2 Reply by madfalcon81

  • madfalcon81
  • Member
  • Offline
  • Registered: 2014-08-05
  • Posts: 242

Re: Model printing doesn't start

No. I had the same problem, switched to Repetier Host.

Fat kids are harder to kidnap!

3 Reply by wtang

  • wtang
  • Member
  • Offline
  • Registered: 2015-03-25
  • Posts: 10

Re: Model printing doesn't start

I had a similar problem with a model I created using SketchUp.  It turned out the STL file that I exported out of SketchUp had some errors that caused my model to be non-printable.  The Slic3r that's built into SoliPrint choked on the STL file without popping up any error messages.  After I repaired my STL fine using netfabb it printed fine using SoliPrint.

4 Reply by ottoangel

  • ottoangel
  • Member
  • Offline
  • Registered: 2015-01-29
  • Posts: 29

Re: Model printing doesn't start

Make sure you have your computer set to English (USA).