1 Topic by bubblefrog

  • bubblefrog
  • Member
  • Offline
  • Registered: 2014-08-17
  • Posts: 14

Topic: Bed not level

Hello I did some research on my Press today, i took it apart and checked if there was something that could be done to increase print quality.
I did some measurements of the bed and noticed that it's about 3.5mm lower in the front compared to the back of the bed, so now to my question, is there any way of leveling it manually?

2 Reply by jagowilson

  • jagowilson
  • PRINTiT
  • Offline
  • Registered: 2014-09-14
  • Posts: 1,701

Re: Bed not level

http://www.soliforum.com/topic/9958/pla … nt-to-back

3 Reply by bubblefrog

  • bubblefrog
  • Member
  • Offline
  • Registered: 2014-08-17
  • Posts: 14

Re: Bed not level

jagowilson wrote:

http://www.soliforum.com/topic/9958/pla … nt-to-back

Thank you, but after i added the screws my bed is still 1.5mm of