<![CDATA[SoliForum - 3D Printing Community — Bed not level]]> https://www.soliforum.com/topic/10472/bed-not-level/ Sat, 21 Mar 2015 19:37:45 +0000 PunBB <![CDATA[Re: Bed not level]]> https://www.soliforum.com/post/90411/#p90411 jagowilson wrote:

http://www.soliforum.com/topic/9958/pla … nt-to-back

Thank you, but after i added the screws my bed is still 1.5mm of

]]> Sat, 21 Mar 2015 19:37:45 +0000 https://www.soliforum.com/post/90411/#p90411 <![CDATA[Re: Bed not level]]> https://www.soliforum.com/post/90177/#p90177 http://www.soliforum.com/topic/9958/pla … nt-to-back

]]> Thu, 19 Mar 2015 17:38:16 +0000 https://www.soliforum.com/post/90177/#p90177 <![CDATA[Bed not level]]> https://www.soliforum.com/post/90163/#p90163 Hello I did some research on my Press today, i took it apart and checked if there was something that could be done to increase print quality.
I did some measurements of the bed and noticed that it's about 3.5mm lower in the front compared to the back of the bed, so now to my question, is there any way of leveling it manually?

]]> Thu, 19 Mar 2015 16:55:56 +0000 https://www.soliforum.com/post/90163/#p90163