1 Topic by leethegeek (edited by leethegeek 2015-02-22 22:04:40)

  • leethegeek
  • Member
  • Offline
  • Registered: 2015-02-16
  • Posts: 12

Topic: Am I missing screws?

While working on an extruder problem on my Press I noticed two holes near where the power and USB plug in that look like they should have screws in them, below is a pic of one of the holes I am talking about, do other people have screws in there?

It wont let me post a pic (says "Too more links in message. Allowed 0 links. Reduce number of links and post it again.") but add an h to the beginning of the below,

ttps://dl.dropboxusercontent.com/u/6256446/missing%20screw.jpg

Thanks

2 Reply by johnrn1967

  • johnrn1967
  • Member
  • Offline
  • Registered: 2015-02-20
  • Posts: 19

Re: Am I missing screws?

Yes, think I used M4 X 10 or 12. helped mine with some of the bed bounce

3 Reply by leethegeek

  • leethegeek
  • Member
  • Offline
  • Registered: 2015-02-16
  • Posts: 12

Re: Am I missing screws?

Yeah the bed definitely bounced more than I thought it should, how in the world did they mess up the production of these so bad?

Thanks for the screw sizes!

4 Reply by albc3d

  • albc3d
  • Member
  • Offline
  • Registered: 2015-02-09
  • Posts: 11

Re: Am I missing screws?

I saw those missing screws, too, when I was trying to figure out why my bed was bouncing so much.  Adding those screws helped a lot, since, before, there was nothing supporting the bottom of the two support rods.  The bed is still a little jerky going down.