<![CDATA[SoliForum - 3D Printing Community — Am I missing screws?]]> https://www.soliforum.com/topic/10124/am-i-missing-screws/ Mon, 23 Feb 2015 03:44:36 +0000 PunBB <![CDATA[Re: Am I missing screws?]]> https://www.soliforum.com/post/86770/#p86770 I saw those missing screws, too, when I was trying to figure out why my bed was bouncing so much.  Adding those screws helped a lot, since, before, there was nothing supporting the bottom of the two support rods.  The bed is still a little jerky going down.

]]> Mon, 23 Feb 2015 03:44:36 +0000 https://www.soliforum.com/post/86770/#p86770 <![CDATA[Re: Am I missing screws?]]> https://www.soliforum.com/post/86740/#p86740 Yeah the bed definitely bounced more than I thought it should, how in the world did they mess up the production of these so bad?

Thanks for the screw sizes!

]]> Mon, 23 Feb 2015 01:10:03 +0000 https://www.soliforum.com/post/86740/#p86740 <![CDATA[Re: Am I missing screws?]]> https://www.soliforum.com/post/86727/#p86727 Yes, think I used M4 X 10 or 12. helped mine with some of the bed bounce

]]> Mon, 23 Feb 2015 00:12:39 +0000 https://www.soliforum.com/post/86727/#p86727 <![CDATA[Am I missing screws?]]> https://www.soliforum.com/post/86706/#p86706 While working on an extruder problem on my Press I noticed two holes near where the power and USB plug in that look like they should have screws in them, below is a pic of one of the holes I am talking about, do other people have screws in there?

It wont let me post a pic (says "Too more links in message. Allowed 0 links. Reduce number of links and post it again.") but add an h to the beginning of the below,

ttps://dl.dropboxusercontent.com/u/6256446/missing%20screw.jpg

Thanks

]]> Sun, 22 Feb 2015 22:04:17 +0000 https://www.soliforum.com/post/86706/#p86706