1 Topic by TheElCaminoKid

  • TheElCaminoKid
  • Member
  • Offline
  • Registered: 2014-01-05
  • Posts: 12

Topic: SD2 Run Job...*Long Pause*... Print?

Hello folks,
Working on a SD2 with RepV0.85b
Use to be I would hit run job after slicing, extruder would move into position and immediately start printing.
Now however, I click print job, extruder moves into position, touching the print bed, retracting a few mm, then go back down to the print bed, and just stops... for around 10 or so seconds. causing the plastic to glob around the extruder.
needless to say this causes me a headache every time I initiate a print, regardless of what i'm printing. .
Any ideas?
Thanks
-Ryan

2 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: SD2 Run Job...*Long Pause*... Print?

Can you post your start Gcode?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.