1 Topic by Hyper_Cube

  • Hyper_Cube
  • Hyper_Cube
  • Member
  • Offline
  • Registered: 2014-01-05
  • Posts: 40

Topic: Advanced Flow Rate Question

I'm re-calibrating my machine as I haven't done it in ages. I just just finished calibrating extrusion length and am back to messing with my flow rate and printing calibration cubes. Instead of changing my extrusion multiplier, is there somewhere else that allows me to change that setting? I vaguely remember messing with something else last time I did it.

SD3, E3D Hot End,
Heated Glass Bed,
Bulldog XL Geared Metal Extruder

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Advanced Flow Rate Question

EEPROM steps per mm for what goes in. 
Extrusion multiplier for your single wall thickness .48
Flow rate and Feed rate should both be at 100.
That is the correct way to do it.
I don't know of any other way to manipulate the extrusion multiplier.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website