1 Topic by masteredwood (edited by masteredwood 2015-02-06 22:23:54)

  • masteredwood
  • Newbie
  • Offline
  • Registered: 2015-02-06
  • Posts: 2

Topic: My Extrude Engine wont work!

I just bought my printer and got it calibrated, but when i went to load up the filament the feeder motor just clicks and stutters in place slightly.  I don't know what to do.

Solidoodle Workbench btw...  And extruder 2 works fine.

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: My Extrude Engine wont work!

Switch the motor wires and if the problem moves to the other motor than you have a VREF or stepper driver issue.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website